This allows you to have textured strokes.
This parameter always shows up as two parameters:
- Which pattern you'll be using.
- The size of the pattern. 1.0 is 100%.
- Horizontal Offset & Vertical Offset
- How much a brush is offset, random offset sets a new per stroke.
- Texturing mode
- Uses alpha multiplication to determine the effect of the texture. Has a soft feel. - Uses substraction to determine the effect of the texture. Has a harsher, more texture feel.
- Cutoff policy
Cutoff policy will determine what range and where the strength will affect the textured outcome.
- doesn't cut off. Full range will be used.
- cuts the pattern off. - Cuts the brush-tip off.
- Cutoff is... the grayscale range that you can limit the texture to. This also affects the limit takes by the strength. In the below example, we move from the right arrow moved close to the left one, resulting in only the darkest values being drawn. After that, three images with larger range, and underneath that, three ranges with the left arrow moved, result in the darkest values being cut away, leaving only the lightest. The last example is the pattern without cutoff.
- Invert Pattern
- Invert the pattern.
This allows you to set the texture to Sensors. It will use the cutoff to continuously draw lighter values of the texture(making the result darker)
David Revoy describing the texture feature(old)
This page was last modified on 31 January 2015, at 11:27. Content is available under Creative Commons License SA 4.0
unless otherwise noted.