Kdenlive/Manual/Installation/da: Difference between revisions

Revision as of 13:42, 2 October 2011

Other languages:

Installation

Installation af binære pakker

Multimediepakker gøres tilgængelige i mange alternative arkiver, ofte på grund af begrænsninger i retten til at distribuere codecs på grund af patenter i nogle lande (for øjeblikket især USA).

I en perfekt verden ville pakkebyggere bidrage til officielle distributioner og de der laver multimedieindhold ville holde sig til frie codecs for at udbrede brugen af dem over hele verden ... Så prøv at holde dig til, hvad din distribution leverer.

Debian, Ubuntu og afledede distributioner

Debian-projektet leverer pakker med Kdenlive fra "squeeze"-udgaven (6.0), men for at drage nytte af de seneste opdateringer og fejlrettelser, så kan du overveje at opgradere til en "testing"-udgave eller endda "sid".

Ubuntu leverer også Kdenlive siden "gutsy" (7.10), men af tilsvarende grunde er det at foretrække at opgradere til den seneste udgave.

I begge tilfælde skulle et simpelt apt-get install kdenlive virke.

Fedora, RedHat and derivatives

RPM packages are not yet maintained in official branch, so you must go through unofficial RPM Fusion repository. Follow the site recommendations to make them available and end with yum install kdenlive

Gentoo, Arch, BSD ports

Building scripts are ready for up-to-date systems, so run respectively emerge kdenlive or pacman -S kdenlive or pkg_add kdenlive, etc.

Installing from source

If you want to test latest committed code or your personal patches, you will have to build Kdenlive (and probably MLT) on your own.

You can use your distribution's package building procedure to use its software management system to install/upgrade/remove the binaries and data, and eventually share your builds (and even contribute to package maintainance - refer to the respective distribution manual).

If you prefer you can build & install Kdenlive to a local area (preferably not /usr, but rather /usr/local or $HOME/my_local_builds/kdenlive-last-release or similar). It is then recommanded to use the build script ^[1]

↑ on distributions older than Debian 6 or Ubuntu 10.04 and derivatives, you need to set ENABLE_SWFDEC=0 in the config variables of the script

[1] stributions older than Debian 6 or Ubuntu 10.04 and derivatives, you need to set ENABLE_SWFDEC=0 in the config variables of the script

[1]

@@ Line 15: / Line 15: @@
 ''Ubuntu'' leverer også '''Kdenlive''' siden "gutsy" (7.10), men af tilsvarende grunde er det at foretrække at opgradere til den seneste udgave.
-In both cases a simple <code>apt-get install kdenlive</code> should then work.
+I begge tilfælde skulle et simpelt <code>apt-get install kdenlive</code> virke.
 ==== Fedora, RedHat and derivatives ====