Difference between revisions of "Kdenlive/Manual/Useful Information/Tips Tricks"
(formatting changes) |
m |
||
| Line 24: | Line 24: | ||
<!--T:6--> | <!--T:6--> | ||
{{Prevnext2 | {{Prevnext2 | ||
| − | | prevpage=Special:MyLanguage/Kdenlive/Manual/Useful_Information/ | + | | prevpage=Special:MyLanguage/Kdenlive/Manual/Useful_Information/Surround_Sound | nextpage=Special:MyLanguage/Kdenlive/Manual/Useful_Information/Useful_Resources |
| − | | prevtext= | + | | prevtext=Surround Sound | nexttext= Userful Resources |
| index=Special:MyLanguage/Kdenlive/Manual | indextext=Back to menu | | index=Special:MyLanguage/Kdenlive/Manual | indextext=Back to menu | ||
}} | }} | ||
Revision as of 17:51, 20 September 2013
Information
- Like: Setting in/out points for a clip, then dragging it from the _clip monitor_ (not project tree) to the timeline adds the selected section only
- Or: Timeline zoom by vertical drag on the ruler (if enabled in settings)
- Clip monitor settings like frame dropping
Tips & Tricks
- You can advance and retard the clip in the project monitor by rotating the mouse wheel when the pointer is over the timeline ruler or over the project monitor
- You can advance and retard the clip in the clip monitor by rotating the mouse wheel when the pointer is over the clip monitor
- You can zoom the timeline by vertical drag on the ruler (if enabled in Settings -> Configure Kdenlive -> Timeline)
- What's this Full Luma Range
This page was last edited on 20 September 2013, at 17:51. Content is available under Creative Commons License SA 4.0 unless otherwise noted.