Krita/Manual/BrushEngines/SketchBrush

Revision as of 11:00, 26 July 2015 by Zort (Talk | contribs) (Offset Scale)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

A line based brush engine, based on the Harmony brushes. Very messy and fun.

Reference

Parameters

Has the following parameters:

Brush Size

Line Width

The width of the rendered lines.

Krita 2 9 brushengine sketch linewidth.png

Offset Scale

When curve lines are formed, this value roughly determines the distance from the curve lines to the connection lines:

  • This is a bit misleading, because a value of 0% and a value of 100% give similar outputs, as do a value of say 30% and 70%. You could think that the actual value range is between 50% and 200%.
  • 0% and 100% correspond to the curve lines touching the connection lines exactly.
  • Above 100%, the curve lines will go further than the connection lines, forming a fuzzy effect.

Krita 2.9 brushengine sketch offset.png

Krita-sketch offset scale2.png

Density

The density of the lines. This one is highly affected by the Brush-tip, as determined by the Distance Density toggle.

Krita 2.9 brushengine sketch density.png

Use Distance Density
the further the line covered is from the center of the area of effect, the less the density of the resulting curve lines.
Magnetify
Magnetify is on by default. It's what causes curve lines to form between two close line sections, as though the curve lines are attracted to them like magnets.
With Magnetify off, the curve line just forms on either side of the current active portion of your connection line. In other words, your line becomes fuzzier when another portion of the line is nearby, but the lines don't connect to said previous portion.
Random RGB
Causes some slight RGB variations.
Random Opacity
The curve lines get random opacity. This one is barely visible, so for the example I used line width 12 and 100% opacity.
Distance Opacity
???
Simple Mode
this mode exists for performance reasons, and doesn't affect the output in a visible way. Check this for large brushes or thick lines for faster rendering.
Paint Connection Line
What appears to be the connection line is usually made up of an actual connection line and many smaller curve lines. The many small curve lines make up the majority of the line. For this reason, the only time this option will make a visible difference is if you're drawing with 0% or near 0% density, and with a thick line width. The rest of the time, this option won't make a visible difference.

This page was last modified on 26 July 2015, at 11:00. Content is available under Creative Commons License SA 4.0 unless otherwise noted.