Archive:Kdenlive/Manual/Transitions: Difference between revisions

From KDE UserBase Wiki
m (typo)
Line 24: Line 24:


== List of Transitions ==
== List of Transitions ==
see also [[Kdenlive/Manual/Effects_And_Transitions]] for an alphabetical list of effects and transitions.


# [[Special:myLanguage/Kdenlive/Manual/Transitions/addition|addition]]
# [[Special:myLanguage/Kdenlive/Manual/Transitions/addition|addition]]
Line 56: Line 58:
# [[Special:myLanguage/Kdenlive/Manual/Transitions/Wipe|Wipe]]
# [[Special:myLanguage/Kdenlive/Manual/Transitions/Wipe|Wipe]]
# [[Special:myLanguage/Kdenlive/Manual/Transitions/Xfade0r|Xfade0r]]
# [[Special:myLanguage/Kdenlive/Manual/Transitions/Xfade0r|Xfade0r]]


== FAQ: ==
== FAQ: ==

Revision as of 10:56, 30 June 2012

Transitions

Transitions govern how Kdenlive cuts from one clip to the next. You can add many different transition effects using Kdenlive's transitions.

To add a transition, adjust clips in the time line so that the end of one overlaps with the begining of of another.


And then right click in the time line at the overlap point, select Add Transition and then choose one of the transitions from the flyout.

see Kdenlive/Manual/QuickStart#transition






































If you select the transition in the timeline its properties will appear in the Transition tab. (If this is not visible then use View > Transitions to add it)

You should preview your transition to make sure it is running in the direction you expect. For example if it is a disolve transition and it is running in the correct direction then then the first clip should cross dissolve into the second clip. But if it is in the wrong direction the first clip will suddenly dissappear (replaced by the second track) it will then fade back in and then it will abruptly jump to second clip. If your transition is in the wrong direction just select Reverse check box in the Transition list

List of Transitions

see also Kdenlive/Manual/Effects_And_Transitions for an alphabetical list of effects and transitions.

  1. addition
  2. addition_alpha
  3. Affine
  4. alphaatop
  5. alphain
  6. alphaout
  7. alpha over
  8. alphaxor
  9. blend
  10. burn
  11. color_only
  12. Composite
  13. darken
  14. difference
  15. Dissolve
  16. dodge
  17. grain_extract
  18. hardlight
  19. Hue shift
  20. lighten
  21. multiply
  22. overlay
  23. Regionalize
  24. Saturation
  25. screen
  26. Slide
  27. softlight
  28. UV Map
  29. value
  30. Wipe
  31. Xfade0r

FAQ:

Q: How to add a cross fading effect

A: Make clips on two tracks overlap in time, then pull the green dot popping-up in the corner of the bottom clip (see Kdenlive/Manual/QuickStart#transition )