KWord can be started one of four ways:
- 1. You can select KWord through the system menus, under: K-Button->Office->KWord.
- 2. If you are in a terminal program (Konsole, Xterm, etc.), you can type:
$ kword &
$ kword filename &
- 3. Using Konqueror, you can click on your data file (KWord documents end in .kwd). This will automatically start KWord and begin editing the file.
- 4. Using the KOffice Workspace.
|What parts of this guide should I read?||Introduction to Templates|
This page was last edited on 17 August 2012, at 17:07. Content is available under Creative Commons License SA 4.0 unless otherwise noted.