Kdenlive/Manual/Monitors/Clip Monitor RightClick

From KDE UserBase Wiki
Revision as of 06:51, 12 August 2012 by Ttguy (talk | contribs) (→‎Save zone)

Clip Monitor - Right Click Menu

Play ...

Play

Play Zone

Loop Zone

Go To

Go to Project Start

Go to Previous Snap Point

Go to Zone Start

Go to Clip Start

Go to Clip End

Go to Zone End

Go to Next Snap Point

Go to Project End

Markers

Add Marker

Adds a new marker into the clip at the current time point.

Edit Marker

Brings up a dialog where you can edit the marker that is at the current time point. Use Go to marker to put the monitor at the marker you want to edit.

Delete Marker

Deletes the marker that is a the current timepoint. Use Go to marker to put the monitor at the marker you want to edit.

Delete All Markers

Deletes all the markers from the current clip.

Go to marker...

Same a Go to Marker below.

Go to marker...

The menu item pops out a list of existing markers to select from. When one is selected the Clip monitor moves to that marker.

Save zone

This brings up the Save Zone dialog

This causes the current zone (see Creating Zones in Clip Monitor) to be saved as a .mlt file. This is a MLT video playlist file which is an xml format file describing the zone that we saved.

You can then load the .mlt files as clips into the project monitor and edit them like any other clip.

Extract Zone

This brings up the Cut Clip dialog which appears to be setup to extract the zone into a new file and add it to the project tree.

On the authors 0.9.2 version of kdenlive this feature is broken

ffmpeg version 0.8.3-4:0.8.3-0ubuntu0.12.04.1, Copyright (c) 2000-2012 the Libav developers
 built on Jun 12 2012 16:37:58 with gcc 4.6.3
[dv @ 0x9d71480] Can't initialize DV format!
Make sure that you supply exactly two streams:
    video: 25fps or 29.97fps, audio: 2ch/48kHz/PCM
    (50Mbps allows an optional second audio stream)
Output #0, dv, to '/home/ttguy/Videos/Tape3_006_0.dv':
 Metadata:
   encoder         : Lavf53.21.0
   Stream #0.0: Video: dvvideo, yuv420p, 720x576 [PAR 64:45 DAR 16:9], q=2-31, 28800 kb/s, 90k tbn, 25 tbc
   Stream #0.1: Audio: pcm_s16le, 32000 Hz, 2 channels, 1024 kb/s
Stream mapping:
 Stream #0.0 -> #0.0
 Stream #0.1 -> #0.1
Could not write header for output file #0 (incorrect codec parameters ?)

Extract frame

Extracts the frame currently in the clip monitor as a .PNG image which you can save to the file system.

Set current image as thumbnail

This will change the thumbnail that represents this clip in the project tree to the frame that is currently selected in the clip monitor.

Monitor overlay infos

???

Real time (drop frames)

Setting this to the Checked state means the clip monitor will drop frames durring playback to ensure the clip plays in real time. This does not effect the final rendered file - it just effect how the clip appears when being previewed in the clip monitor