Digikam/Verificar la base de dades

This page is a translated version of the page Digikam/Check Database and the translation is 89% complete.
Outdated translations are marked like this.
Other languages:
Deutsch • ‎English • ‎català • ‎dansk • ‎українська

Verificar i optimitzar les bases de dades al digiKam

Transcrit des d'un article al blog d'en Dmitri Popov, el 19 de desembre de 2011

By default, digiKam uses two SQLite databases for storing essential data: digikam4.db and thumbnails-digikam.db. And to make the application run fast and smoothly, it’s a good idea to check and optimize the databases every now and then. To do this on Ubuntu or its derivatives, you need to install the sqlite3 package using the sudo apt-get install sqlite3 command. Once you’ve done that, back up the digikam4.db and thumbnails-digikam.db databases. Open then the terminal and switch to the directory where the databases are stored. First off, you should check the integrity of both databases using the following commands:

sqlite3 -line digikam4.db 'pragma integrity_check;'
sqlite3 -line thumbnails-digikam.db 'pragma integrity_check;'

Si les dues bases de dades estan en ordre, hauríeu de veureu el missatge

integrity_check = ok

Per optimitzar les bases de dades, executeu les dues ordres a continuació:

1-sqlite3 -line digikam4.db 'vacuum;'
sqlite3 -line thumbnails-digikam.db 'vacuum;'

Executeu a continuació la verificació de la integritat una vegada més per assegurar-vos que tot funciona correctament, i ja està.

This page was last edited on 4 July 2019, at 13:00. Content is available under Creative Commons License SA 4.0 unless otherwise noted.